Change papersize in viewer

[JuanVelazquez]

Good morning I tried to make a change in size on the sheet to print via Viewer, I need the blade to be 5.50 cm x 5.80 cm but I have not managed to make it.

The syntax of the command used is:
OPEN (1, OPT ="PAPERWIDTH=550; PAPERLENGTH =580; papersize = 256") "*VIEWER*"

I await your help.

Regards

[Mike King]

The non-PDF viewer does not support rendering based on Paper size, however as of PxPlus 2018 update 1 the PDF based viewer does. 

You might want to try this viewer.