Main Board > Webster Plus

EZWeb takes approx 20 seconds for actions

(1/3) > >>

Jon Toomsen:
Running Windows 10.
I've switched pxplus from basic to web 64 bit.
Installed Webster plus using pxplus ez web server.
Update Lib and Editors.
It takes about 20 seconds to switch from inspector to setup.
Any action takes as long. When using basic did not take so long. Both versions are 2023.

Devon Austen:
Hi Jon,

Did you just switch the license used or did you switch from 32-bit to 64-bit as well. Or did you switch to a different install?

One thought is anti-virus software could be doing scans on the new install but the old one was white listed?

Jon Toomsen:
I switched from 32 bit to 64 bit doing a fresh install.
Other programs work well its just webster taking so long.
Disabled anti virus for a while - did not make any difference.

Mike King:
Are you connecting to your own machine and if so what URL are you using? 

I have seen instances where Windows has issues with resolving localhost if you have both IPv4 and IPv6 enabled.
If using localhost try using the direct IP address of 127.0.0.1

The issue is that localhost often has two definitions -- one for IPv4 (127.0.0.1) and one for IPv6  (::1).  I have seen this get things confused as the browser first tries the ::1 address then the 127.0.0.1.

Jon Toomsen:
if the Ide is not in use the ezweb actions act normally as you would expect.
if the Ide is launched the ezweb introduces a pause for actions.
The admin logon user - Last known IP address:   ::ffff:127.0.0.1 in either case.

Navigation

[0] Message Index

[#] Next page