This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Language / PRE_REMOVE IO Issue
« on: November 10, 2020, 05:15:58 PM »
I am trying to intercept a REMOVE and prevent it under certain circumstance.
I have an IO proc defined. I hit the PRE_REMOVE: block.
I decide that I want to disallow the REMOVE.
I have tried: EXIT 0, EXIT 61, ESCAPE 61, and several other values.
In each case, I get an error generated. And end up aborting the process. When I go back in, the record was in fact removed.
Any ideas on how to deal with this? I am on PxPlus 15.1.
Thanks!
I have an IO proc defined. I hit the PRE_REMOVE: block.
I decide that I want to disallow the REMOVE.
I have tried: EXIT 0, EXIT 61, ESCAPE 61, and several other values.
In each case, I get an error generated. And end up aborting the process. When I go back in, the record was in fact removed.
Any ideas on how to deal with this? I am on PxPlus 15.1.
Thanks!
Pages: [1]