PxPlus User Forum
Main Board => Discussions => Language => Topic started by: Tim Plotner on November 10, 2020, 05:15:58 PM
-
I am trying to intercept a REMOVE and prevent it under certain circumstance.
I have an IO proc defined. I hit the PRE_REMOVE: block.
I decide that I want to disallow the REMOVE.
I have tried: EXIT 0, EXIT 61, ESCAPE 61, and several other values.
In each case, I get an error generated. And end up aborting the process. When I go back in, the record was in fact removed.
Any ideas on how to deal with this? I am on PxPlus 15.1.
Thanks!
-
You might try a RETURN 1 to indicate that the remove was successful but that will by-pass the actual remove.
Generating an error is likely going to be problematic.