Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Off Topic / seasoned developer available
« on: August 08, 2019, 06:31:52 PM »
over 30 years experience in Business Basics since mid 80's - (Basic-IV, Rexxon, Tbred, BBx and of course PxPlus)
over 15 years Pxplus/Providex & Nomads
I take special pride in my productivity, attention to detail and quality results.
I am looking forward to being a leading integral element of an enterprise that would markedly benefit from including
an innovative, resourceful and seasoned resource as a competent and valuable contribution to its development team.
Samuel Genzen
samg@profprog.com
over 15 years Pxplus/Providex & Nomads
I take special pride in my productivity, attention to detail and quality results.
I am looking forward to being a leading integral element of an enterprise that would markedly benefit from including
an innovative, resourceful and seasoned resource as a competent and valuable contribution to its development team.
Samuel Genzen
samg@profprog.com
2
Programming / .NET
« on: February 10, 2019, 02:54:20 PM »
Was chatting with a Sage100 (previously Mas90/200) developer who was telling me the latest Providex 9.5 for Sage .... " One thing that Sage's Providex does has is direct .NET support. Amazingly, it works quite well. "
was wondering
1) What exactly does 9.5 do that means "DIRECT" .NET support
2) I know that much of the young IT crowd asks "is there .NET support?" was wondering if that might be in the works for future pxplus releases
was wondering
1) What exactly does 9.5 do that means "DIRECT" .NET support
2) I know that much of the young IT crowd asks "is there .NET support?" was wondering if that might be in the works for future pxplus releases
3
Nomads / grid button
« on: August 29, 2018, 01:06:20 PM »
I have a grid with a 'button' as one of the columns
if I simply move to that column using arrows, then move out again, the "change" logic is executed even
when the button wasn't pressed.
this occurs even when the column is locked
is there a way to prevent this? and/or is there a way to check if the button was pressed? (I think one of the CTL values?)
thx
if I simply move to that column using arrows, then move out again, the "change" logic is executed even
when the button wasn't pressed.
this occurs even when the column is locked
is there a way to prevent this? and/or is there a way to check if the button was pressed? (I think one of the CTL values?)
thx
Pages: [1]