Hello Forum :
We have recently installed Pxplus 15 on our CentOS Linux servers.
All of our programs (still all character-based) are executing properly, so far.
One odd behaviour is that if a program is sitting at an INPUT statement,
or even just at a Pxplus prompt, pressing the ESC key, after a brief pause,
behaves the same as if the user had pressed <Enter>. The program proceeds
and a CTL value of zero is returned. This did not work exactly the same way in
Providex 9.10. I checked the manual for System Parameters, but none were
specifically related to the ESC key. The keypress does still generate a hex $1B$.
Is there a way to switch this off? Or is the ESC key needed to exit some GUI routines?
Thanks,
Bill.