This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
Programming / Re: Help with Initial Value Load Error
« on: April 12, 2024, 06:14:49 PM »
WOW! Amazing, I was using CMD_STR$="UPanelName" to open the panel from the menu but changing it to PROCESS fixed the listbox error, THANKS A BUNCH!, I gotta try the other methods too just in case.
2
Programming / Help with Initial Value Load Error
« on: April 12, 2024, 01:04:08 PM »
Hello
I'm working on a software for a client but I'm having an issue with a Listbox.
The program goes from:
-Log in Screen
- - Main Menu
- - - Chart of Accounts
When I enter the COA panel it loads everything well, the panel has only one listbox.
The problem is that when I pickup something from the listbox and close the panel, then reopen it, it gives me the following error:
"""""""""""
LOAD ERROR
Unable to set initial value for Listbox @(etc,etc)
Value that failed is etc,etc (whatever record I picked before closing)
"""""""""""
Then I just click "Ok" on the screen error and the panel keeps running normally, how can I skip that initial value?
Is there a command or something to release that value when closing the panel so that when I open the panel again it does not try to find what was selected before?
Thank you very much!
I'm working on a software for a client but I'm having an issue with a Listbox.
The program goes from:
-Log in Screen
- - Main Menu
- - - Chart of Accounts
When I enter the COA panel it loads everything well, the panel has only one listbox.
The problem is that when I pickup something from the listbox and close the panel, then reopen it, it gives me the following error:
"""""""""""
LOAD ERROR
Unable to set initial value for Listbox @(etc,etc)
Value that failed is etc,etc (whatever record I picked before closing)
"""""""""""
Then I just click "Ok" on the screen error and the panel keeps running normally, how can I skip that initial value?
Is there a command or something to release that value when closing the panel so that when I open the panel again it does not try to find what was selected before?
Thank you very much!
Pages: [1]