Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: 1 [2]
16
Programming / Remote Debugging via IT
« on: November 07, 2018, 09:49:46 PM »
I am looking for some guidance to run remote debugging through Windx.
My setup is this
Using a PC to develop and the server is a Linux Server.
I can launch Windx and then do a RUN "*it" which opens the local IT program editor but I am at a loss where to go from there.
I try to open a file in the editor and get the file system on the Linux box but when choosing a file to work on I get an error
File Open Error
the file "/pxplus/STARTUP" cannot be opened at this time
Error #13: File access mode invalid
Thanks for any help you can offer.
My setup is this
Using a PC to develop and the server is a Linux Server.
I can launch Windx and then do a RUN "*it" which opens the local IT program editor but I am at a loss where to go from there.
I try to open a file in the editor and get the file system on the Linux box but when choosing a file to work on I get an error
File Open Error
the file "/pxplus/STARTUP" cannot be opened at this time
Error #13: File access mode invalid
Thanks for any help you can offer.
Pages: 1 [2]