PxPlus User Forum

Main Board => Discussions => Programming => Topic started by: Danilo David on April 05, 2022, 07:44:21 PM

Title: GODEX G530 using commands to print
Post by: Danilo David on April 05, 2022, 07:44:21 PM

hello,
Blessed morning

Anyone knows how to connect and send ZPL or EZPL  commands to GODEX G530 printer?

Thank you very much,

Regards,
Danilo

Title: Re: GODEX G530 using commands to print
Post by: michaelgreer on April 06, 2022, 10:49:11 AM

Danilo,

Configure the printer as you  would any other except in windows use generic/text only as the driver, and don't give it a PxPlus driver. In *nix you can also specify no print driver.  Simply open a channel to the device and print your ZPL or EPL commands.  I have done this literally hundreds of times with different customers.  The biggest mistake is usually to try and use the printer's own driver.

Hope this helps!
Michael