PxPlus User Forum
Main Board => Discussions => Programming => Topic started by: JuanVelazquez on November 06, 2018, 12:26:14 PM
-
Good morning I tried to make a change in size on the sheet to print via Viewer, I need the blade to be 5.50 cm x 5.80 cm but I have not managed to make it.
The syntax of the command used is:
OPEN (1, OPT ="PAPERWIDTH=550; PAPERLENGTH =580; papersize = 256") "*VIEWER*"
I await your help.
Regards
-
The non-PDF viewer does not support rendering based on Paper size, however as of PxPlus 2018 update 1 the PDF based viewer does.
You might want to try this viewer.